Guide

Outdoor festival sound in Japan: planning for power and noise

2026.09.15 · Meta Audio

Two things decide whether an outdoor event in Japan runs smoothly, and neither is the line-up. They are power and noise. Both are much easier to deal with months ahead than on the day.

Power

Know what the system needs

A sound company should be able to tell you, in writing, how much power the system requires and in what form. If the answer is vague, ask again. A compact system will run from ordinary 100V outlets on separate circuits. A festival system needs a dedicated supply, which outdoors almost always means a generator.

Size the generator with headroom

Bass is what draws current, and it draws it in bursts. A generator sized exactly to the average load will sag on every kick drum. Allow a healthy margin, and keep sound on its own supply, separate from catering, lighting and anything with a heating element.

Mind the frequency

Japan runs on 50 Hz in the east and 60 Hz in the west. Modern professional amplifiers cope with both, but it is worth confirming for every piece of equipment coming to site, especially anything an artist brings from overseas.

Plan the cable runs

Where the generator sits affects both noise at the stage and how much heavy cable has to cross the site. Put it as far from the audience as practical, downwind if you can, with a protected route for the cable.

Noise

Find out the real limit

Ask the landowner and the local authority what has been agreed: a level, a finish time, or both. Ask where it will be measured. A limit at the site boundary is a very different thing from a limit at the nearest house.

Point the stage the right way

The single most effective decision is free: which direction the stage faces. Aim it away from the nearest homes and towards open land, hillside or trees.

Use directional bass

Low frequencies spread in every direction and travel furthest. Arranging bass enclosures as a cardioid or end-fire array cancels much of their output behind the stage. You give up a little efficiency and gain a great deal of goodwill.

Cover the back with delays

If the crowd stretches a long way back, turning the main system up is the wrong answer. A set of delay loudspeakers part-way down the field keeps the level even and the overall volume lower.

Agree levels before doors

Decide working levels with your sound engineer in daylight, and decide who has the authority to ask for them to change. Then check at the boundary during the event, especially late at night when the air cools and sound carries further.

A short checklist

  • Written power requirement from your sound supplier.
  • Generator sized with margin, on a supply of its own.
  • Noise conditions confirmed, including where they are measured.
  • Stage direction chosen with neighbours in mind.
  • Bass arrangement and delays included in the system design.
  • One named person responsible for levels on the night.

We plan all of this as part of event production. If you have a site in mind, send us the map.